How to run the RCU - DRORC - Busybox setup
How to run the RCU - DRORC - Busybox setup
This shall be a step by step introduction on how to operate the setup and test Busybox firmware. For now this will be a collection of the necessary steps, but in a later stage the configuration part will become more automated.
You need access to the following systems: - DRORC PC - RCU - Busybox - Local trigger unit (LTU)
Setting up the system and getting ready to take data:
More general stuff
- Log into the Drorc machine as the date user.
- Configure the RCU with the conf-rcu alias. This sets up the RCU and configures the Front End Cards (FECs).
- Execute the /etc/boot/S40... script on the RCU-DCS. This changes the trigger from a software trigger to the DCS trigger intput.
- Start the infoBrowser on the drorc machine with the command "infoBrowser".
- Start date with the command "startdate".
- Log into the LTU: "ssh -X ltu@vme1".
This is the general setup and configuration done. Continue with the the setup of the LTU.